HiCON Plugin: 2.03.29, Board: 7866, Serial: F2971C, FW: 4.07, FPGA: A1B3, IP: 192.168.0.99, AdapterIP: 192.168.0.10



HOMING ERROR: Axis:4 not enabled. Check Mach Config






Do Cycle Start
Cycle Stopped
ERROR: Connection to HiCON has timed out... (5151.012800ms)
ERROR: HiCON disconnected
ERROR: No HiCON Controller Found
HiCON Plugin: 2.03.29, Board: 7866, Serial: F2971C, FW: 4.07, FPGA: A1B3, IP: 192.168.0.99, AdapterIP: 192.168.0.10


Do Cycle Start
THC Setup Sequence Aborted





Do Cycle Start
THC Setup Sequence Aborted

ERROR: Motion Sequence error detected. For more information see the debug screen
ERROR: Unable to ARM. HiCON (System Status 1073741828)







Do Cycle Start
THC Setup Sequence Aborted

ERROR: Motion Sequence error detected. For more information see the debug screen

Axis 3 commanded while disabled

Do Cycle Start
THC Setup Sequence Aborted

ERROR: Motion Sequence error detected. For more information see the debug screen


Do Cycle Start
THC Setup Sequence Aborted



Axis 3 commanded while disabled

Do Cycle Start
THC Setup Sequence Aborted

